Ford 8N

$5,500.00 CAD


The following repairs have been done to this equipment:

  • Service carburetor and distributor, supplying all necessary parts to ignition system.
  • Replace starter solenoid, key switch, ignition resistor assembly.
  • Replace ammeter and oil pressure gauge.
  • Replace exhaust manifold, manifold gaskets, muffler clamp kit.
  • Replace rear axle seals, machine brake drums, replace brake shoes, adjust brakes.
  • Replace lower radiator hose, clean radiator.
  • Supply 3PH check chain & clevis kits, 3PH Cat I top link.
  • Supply new alternator, terminal block, alternator connector, alternator pulley fan belt, all new wiring enclosed in wire loom.
  • Replace piston rings on 3PH hydraulic lift piston, wash diff, transmission, and hydraulic compartments, supply new lubricant.
  • Engine oil and filter replacement.
  • Replace bearings on steering shaft in storage box.
  • Supply silica sand, primer, paint, reducer, hardener to complete paint job to tractor [4 colours involved]
  • Supply new steering wheel.
  • Repair fuel tank.
  • Install lights, switch and inline fuse.
  • To supply new 12-volt 600CA battery at time of sale.




Engine Four-cylinder, L-head, naturally aspirated, 120 C.I.D. with oil bath air cleaner
Transmission Four forward spreads with one reverse spread
Hydraulic lift Category I 3PH lift system
PTO 540 RPM Transition PTO
Electrical 12-volt negative ground full instrumentation (oil pressure, ammeter)
Charging system Alternator equipped; headlights and rear work light included
Tires 6" x 16" triple-rib front wheels, 6-bolt rims; 11.2" x 28" rear tractor tires
Fenders Clamshell-style over rear wheels
Brakes Individual brake pedals for each wheel, or apply both pedals simultaneously